What is the fuel mixture for Homelite trimmer?
Fuel Mixture This Homelite gas trimmer runs on a 50:1 mix of unleaded automobile gasoline and two-cycle engine oil. That is equivalent to 2.6 fluid ounces (80 ml.) of oil to one gallon of gasoline or 4 tsp.
Who makes Homelite gas trimmers?
Techtronic Industries
John Deere acquired the brand in 1994. Techtronic Industries acquired Homelite from John Deere in 2001. Homelite has shifted its production primarily to consumer level lawn and garden equipment and light duty chainsaws.
What is the oil to gas ratio for 50 to 1?
For a 50:1 ratio of gas to oil, use 2.6 fluid ounces of oil per gallon of gas. For a 40:1 mixture, use 3.2 fluid ounces of oil per gallon of gas.
How do you adjust the carburetor on a Homelite Super 2?
Set the High-Speed Screw Adjust the Homelite chainsaw carburetor by turning the high- and low-speed screws as needed. Set the high speed screw by adjusting the screw marked “H.” Pull the trigger so that the throttle opens as wide as possible. Turn the screw to the left and note the engine performance.
How do you extend the cord on a strimmer?
Hold the trimmer head above the ground, press the trigger throttle and allow new line to automatically feed from the spool. Continue to hold the trigger throttle down until the line extends to the point where the blade on the trimmer guard trims it to length.
What is the fuel mixture for a Homelite Super 2 chainsaw?
Engine oil should be mixed with gasoline at a specified ratio before fueling the machine. When refueling with Homelite oil, mix oil with unleaded gasoline at a ratio specified on the container. For other two-stroke engine oils, Homelite recommends mixing one part oil with 16 parts gas.
Why does my trimmer line run out so fast?
It is located inside the trimmer head. If the line is too thick or too thin it can continuously feed the line. Make sure you are using the correct line thickness rated for your machine. The trimmer head is the unit that houses the spool, cap and spring, and lever (in some models).
How long should a strimmer cord be?
The length to which the lines should be cut also varies, from around 10′ to 25′. If you are not sure, err on the side of too long; you can always cut it shorter later. Both lines should be cut to the same length. Make sure your trimmer’s engine is turned off.