What do the symbols on a battery charger mean?
LED lit symbols The battery is charging correctly. Charging is complete and the battery is fully charged. The spanner symbol usually means that the battery is being primed or conditioned. There is a delay in charging due to the battery being too hot or too cold. There is a problem with the battery or charger.
What does the code F01 mean on a battery charger?
Internal Shorted Cell Battery – Cannot be charged
F01. Internal Shorted Cell Battery – Cannot be charged. Have battery checked by certified auto service center. Excessive Load on Battery While Charging – Check load.
What do the lights mean on club car charger?
The light begins flashing when the battery state of charge falls below 10%. Charging Confirmation. • The light will flash three times and the reverse buzzer simultaneously will sound three times to. indicate a battery charging session has begun.
What do the blinking lights mean on a battery tender?
If the red light continues to flash, then either the battery voltage is too low (less than 3 volts) or the output alligator clips or ring terminals are not connected correctly. battery is connected properly and the charger is charging the battery.
What do the symbols on power supplies mean?
Power supply The top symbol is for DC barrel plugs, specifying whether the inside or outside is positive. The middle line is input, where the squiggly tilde ~ indicates AC, here mentioning an input voltage range and frequency it’s okay with (these specs amount to worldwide use).
What does F07 mean on a battery charger?
What does this error code mean?
Error Code | Description |
---|---|
F06 | The charger deteced that the battery may be getting too hot (thermal runaway). |
F07 | The charge shut off because its internal temperature exceeds limit. |
F08 | The battery voltage dropped too low during the maintain mode. |
What does Error 2 mean on a battery charger?
Er2. The battery voltage is 0.5V – 1.5V before charging. The battery is defective. Replace the battery.
What does it mean when battery charger flashes red and green?
You have activated Force Mode on the device. Force Mode is designed when the charger cannot detect the battery when it is under 2V.
What does flashing red light mean on battery charger?
Rescuing “bad batteries” indicated by a blinking red light. Occasionally, the charger might show blinking red right to indicate bad batteries. There are several ways to restore batteries that cannot be charged by the charger.
What is on and off symbols?
On/Off Power Button Symbols (I & O) Power buttons and switches are usually labeled with “I” and “O” symbols. The “I” represents power on, and the “O” represents power off.
How do you read a charger output?
Charging power is based on three things: power (P, measured in Watts), current (I, measured in amps or milliamps), and voltage (V, measured in volts). The amount of power is determined by the equation P = IV. In other words, power is the product of current multiplied by voltage.
What does fo5 mean on a battery charger?
F05 Overheated Condition
F05 Overheated Condition – Disconnect charger and allow to cool for 30 minutes. Check for ample ventilation.
What does F08 mean on a battery charger?
What does E11 mean on a charge controller?
Information
Error Code | Error Code Description |
---|---|
E10 | Abnormal communication of controller |
E11 | Under voltage protection of motor controller |
E12 | Hall fault of the motor |
E13 | Controller MOS tube failure |
What should golf cart chargers read?
The ammeter on a 36-volt charger should show at least 15+ amps when the charger is plugged into the golf car, even if the batteries have not been used for a short while. A 15+ amp reading shows that the charger is actually charging, not just humming (humming is NOT an indication that the charger actually works).