How do you make curtains with tie up curtains?
DIY Tie-Up Curtains
- Step 1) Measure your windows and determine what size panels you will need.
- Step 2) Cut out your material.
- Step 4) Prep your edges.
- Step 5) Hem the seems.
- Step 6) Prep your rod pocket and sew it closed.
- Step 7) Prepare your tie ups.
- Step 8) Secure both ties.
How wide should tie up curtains be?
Measure the width of your windows from edge to edge. Add an additional 8 inches to the measurement (This will make the final curtain 4 inches wider than the window. This was a good width for me, but you can make it wider or narrower as needed. Just be sure to add at least 4 inches to account for seams).
How long should a tie up valance be?
Your tie-up valance should be as wide as your window, plus an inch or two on either side to ensure that you’re actually covering up the entire surface. Any larger, and your valance will look oversized or lopsided, so stick to a smaller size that more closely matches the size of your window.
How long should a tie-up valance be?
How do you hang a swag curtain without a rod?
Five Creative Ways to Hang Curtains Without Rods
- Upholstery tacks.
- Tension cables.
- Hook-eye screws and drapery pins.
- Staples and furring strips.
- Cabinet knobs.
How are tie-up valances measured?
When using a decorative rod, the tie-up valance should be the width of your window, from frame edge to frame edge. Once the Tie-Up valance is installed at your window, the ties and length can be adjusted.
How far down should a window valance hang?
Another rule of thumb used by decorators is that the window valance depth should be 1/4 of the overall window height, plus 1 inch. A 60-inch tall window, then, would call for a 16-inch deep valance, while a 48-inch window calls for a valance about 13 inches deep.
How do you hang curtains with rope?
Here are a few ways you can use rope for your curtains: Create tension in the rope by tying the ends directly to the curtain rod brackets. You can also use curtain holdbacks to secure the rope further down the wall. Avoid hanging heavy drapery when using rope in place of a curtain rod.
How do you make a balloon window shade?
Step by Step Instructions for How to Make a DIY Balloon Shade or Curtain
- Step ONE Gather your Supplies & Measure Your Window.
- Step TWO Sew a Hem Around the Fabric for the DIY Balloon Shade.
- Step THREE Hand Sew on Plastic Rings to the DIY Balloon Shade.
How do you hold curtains without a rod?
Rope is an alternative to curtain wire and can complement country or cottage style decor. It’s best teamed with curtains with grommets. Make sure you stretch the rope until it is taut when you fix it to avoid sagging. Cabinet knobs can be used to hang tie-top curtains.
How to sew cute lined DIY curtains?
Sew Sides. At each corner of fabric panel, cut out fabric from double-folded hem to remove some bulk (Image 1). Fold corner over (Image 2), then fold side edge in 1 inch. Fold over another inch to create a double-folded edge that hides raw edges; pin into place and press (Image 3). Sew sides and remove pins.
How to make DIY Summer curtains?
Curtain fabric
How to tie back curtains cleverly?
Tie your curtains with a strand of pearls for a feminine look.
How to measure for DIY curtains?
– Mark the spot where you would like to hang the drapery rod. – Measure to the lowest place that you would like the fabric to hang (either the floor or the bottom of the window). – You will need Rod to Floor Height measurements to order your draperies, but you still need to wait for your draperies to arrive before hanging your hardware.