How do I engage my PTO John Deere?
Push down and forward on PTO switch (A or B) to engage PTO clutch. Pull back PTO switch (A or B) to disengage clutch.
Why wont my blades engage on my John Deere riding mower?
It could be your bearings and your spindle pockets, or spindles, have seized up,” says Oshel. If the blades are stuck, pump some grease into the fitting and carefully work the blades back and forth by hand until they move freely.
Why won’t my blades won’t engage?
Belt-the number one cause for your blades not to engage is that your belt is either stretched or loose causing it to slip or fall off completely. Belt could have snapped also. When you are trying to process too much grass/leaves they could pack up under your deck and push off your belt.
Why wont my blades won’t engage?
Why won’t my blades engage on my riding mower?
Why are my mower blades not spinning?
If your mower blades will not turn after the blade controls have been engaged, your deck belt may be broken. The deck is located directly under the operators seat. This belt spins the mowers blades and runs through a pulley system of idlers. The exact configuration of the deck belt will depend on your model of mower.
How to troubleshoot the PTO system on a John Deere lawn mower?
How to Troubleshoot the PTO System on a John Deere. 1 Step 1. Park the lawn mower on level ground and set the parking brake. 2 Step 2. 3 Step 3. 4 Step 4. 5 Step 5.
How does a PTO clutch work on a lawn mower?
The PTO works off of a 12-volt system. The electric clutch is operated by a switch located on the dashboard of the lawn mower. When the lawn mower is running and the switch on the dashboard is engaged to the “on” position, the blades will start to turn.
Where is the power take off on a John Deere mower?
Most John Deere lawn mowers are equipped with an electric PTO (Power Take Off). The PTO is the mechanism that turns on the blades located under the mower deck.
How do you change the PTO switch on a lawn mower?
Take the negative lead from the volt meter and clip it to the other tab. Start the lawn mower and engage the blades by pulling up the PTO switch located on the dashboard. If the volt meter reads 12 volts, replace the electric PTO.