How do I reset my OKI toner chip?
Answer
- Press Menu = printer displays “Paper Menu”
- Press Next 4x = printer displays “System Menu”
- Press Select 1x = printer displays “Factory Defaults”
- Press Next 7x = printer displays “Reset Toner Life”
- Press Select 1x = printer displays “Resetting Toner Page Count”
- Press Ready.
Where is the toner sensor?
The sensor is located behind a plastic cover on the side of the drum (see below). Remove the plastic cover and give the silver arm a clean with something small and soft (lint free), any toner that has built up on the sensor will be a very fine powder and should be easy to remove.
Where is the toner sensor on a Brother printer?
Before reinstalling the drum unit into the Brother machine, clean the toner sensor. This sensor is located inside the unit in the back and center. It is a black, ‘U’ shaped plastic that sticks straight up. Clean between the two plastic ‘goal posts’ with a dry cloth to remove dust or excess toner.
How do you clean a toner sensor?
Cleaning the Color Toner Density (CTD) Sensor Inside the Printer
- Ensure that the printer is turned off.
- Pull the standard 250-sheet tray out of the printer carefully.
- Push the button on the right hand side and open the front cover.
- Open the belt unit.
- Clean the CTD sensor inside the printer with a clean dry cotton swab.
How does a toner sensor work?
Optical toner sensing. The printer directs a light beam into the toner hopper through a window (light guide). If unblocked by toner, the light exits through an opposite window and is detected by a receiver. When the optical receiver detects light a high percent- age of the time, the printer concludes that toner is low.
How do I restore my printer to factory settings?
- Touch or swipe down the tab at the top of the screen to open the dashboard on the printer control panel.
- Select “Setup” and then select “Printer Maintenance”
- Select “Restore” and then select “Restore Factory Defaults”
- A message appears stating that the factory defaults will be restored.
How do I clean the sensor on my Brother printer?
Open the Top Cover (1) and the Front Cover (2). Wipe off the paper dust accumulated on the Document Scanning Position Sensor (1) with a soft lint-free cloth moistened with water. Wipe off the paper dust accumulated on the Card Sensor (1) with a soft lint-free cloth moistened with water.