How do you sync a Wii Remote permanently?

Article

Table of Contents

Press the Power button on the Wii console to turn it on.
Open the SD Card Slot cover on the front of the Wii console.
Press and release the SYNC button on the inside of the SD Card compartment on the console.
When the Player LED blinking stops, the syncing is complete.

Why is my Wii Remote blinking and then turning off?

The lights on the Wii Remote blink momentarily before turning off means that the Wii Remote is not paired with your system. Follow these steps to allow your Wii Remote to pair (or “sync”) with your Wii console. Unplug the power cord from the Wii console, and let it sit for at least a few seconds.

How do I fix error code 32004 on my Wii?

Possible solutions

Review our Network Status page for any noted outages.
Set up a new connection.
Power cycle your router and modem.
Enter alternate DNS settings into the Wii.
Try an alternate MTU value.
Check for wireless interference.

Why does error code 51330 keep coming up even though my password is correct?

Usually, it happens because you have changed your Wi-Fi password or entered it incorrectly. Switching a router from WEP to WPA encryption without properly configuring both devices may also break the connection. Another potential cause for the problem would be the firewall settings or MAC filter settings of your router.

How do you know if your Wii sensor bar is broken?

Adjust the camera angle and position until you can see the lights in the LCD display.

If the lights are visible, the sensor bar is working.
If the lights are not visible, the sensor bar will need to be replaced. Click here for repair or replacement options for the sensor bar.

Why is my Wii Remote only flashing?

Lights flashing on the Wii Remote indicate that it has not been able to successfully sync with your Wii console.

How do you reset a Wii Remote sensor?

Reset the Wii Remote.

Remove the batteries from the Wii Remote.
Wait 1 minute.
Replace the batteries, re-sync the remote, and see if the problem is resolved.

Can Wii work without sensor bar?

The Wii remote’s accelerometer-based motion control works with or without the sensor bar. You can play games like Tony Hawk’s Downhill Jam and you won’t need a sensor bar to do it. But for titles like Red Steel or for procedures like aiming the bow in Zelda, well, that’s sensor bar territory.

What does error code 51330 mean on the Wii?

Note. This error code indicates the authentication process between the Wii and wireless router or access point failed. This is often caused by the router refusing a connection because an incorrect security key or security type has been entered into the Wii Internet settings.

What does error code 51030 mean on the Wii?

It appears that your Wii console’s Internet connection may be affected by wireless interference. Try the following: Change your wireless router’s channel to 1 or 11. Changing the wireless channel on your router may help.

How do you fix error code 51330 on the Wii?

If your Wii console has the incorrect internet connection security type configured into it, you might see error code 51330 every time you try to connect to the internet via the console. If that is the case, simply changing the connection security type back to WPA2-PSK (AES) should resolve the problem.