What rear axle is in a 2014 Ram 3500 dually?
Only the 3500 models will get the high-output Cummins option (385 hp/850 lb. -ft.) that includes the behemoth 11.8-inch rear axle. All Cummins engine-equipped Ram HDs will run 3.42:1 axle gears.
What standard rear suspension does Ram 3500 have?
STANDARD HOTCHKISS LEAF SPRING REAR SUSPENSION
THE STANDARD HOTCHKISS LEAF SPRING REAR SUSPENSION. STANDARD FOR RAM 3500. Achieving those impressive diesel- and gas-powered figures for Ram 3500 Heavy Duty required a truly remarkable suspension system. The Hotchkiss rear suspension meets every need of this ready-to-work pickup.
What axles are in a Dodge 2500?
Axles. The Dodge Ram features a wide variety of axles. For the front axle of 4×4 Rams, a Dana 44 was used on all 1500 Rams and the early (light-duty) 2500 Rams. However, most of the 2500 and all 3500 Rams use Dana 60 front axles.
How do I know if my RAM has 3.92 rear axle ratio?
Start the truck and put it into neutral. Rotate the rear tire 2 times and count the number of times the drive shaft turns. Close to 4 times = 3.92.
Does Ram 3500 have leaf springs?
One of the benefits of the Dodge Ram is that it is available in three sizes: 1500, 2500 and 3500, and we carry the leaf springs for all of these models. Since the Dodge Ram comes in a half ton, ¾ ton, and 1-ton capacity, we’re confident that we have the leaf springs you need for each of these models.
How much can a 6.7 Cummins tow?
20,000 pounds 1
The 2022 Ram 2500 boasts a maximum payload of 4,010 pounds when equipped with the 6.4L HEMI® V8 engine, and an impressive towing capacity of 20,000 pounds 1 when equipped with the available 6.7L Cummins® Turbo Diesel engine.
What axle is in a 2013 Ram 2500?
The American Axle Manufacturing AAM 9-1/4″ 14 bolt front axle in most 2003-2013 Ram 4x4s is also called the AAM 925 and AA 9-1/4. It is a live, iron beam front axle with a 9-1/4″ hypoid gear set.
Is a 3.92 rear end good for towing?
Which axle ratio you go with will affect your truck’s towing capability, but fuel economy will change too. A higher axle ratio (like the 3.92 we mentioned earlier) will allow for higher towing capability, but it requires higher engine rpm for any given speed and then results in lower fuel economy.
Are 3.92 gears good for towing?
4) 3.92 has 3 unique lower gears for towing. 5) Speed range that 3.21 is better at towing: 31-38 MPH, 48-57 MPH. 6) Speed range that 3.92 is better at towing: 0-30 MPH, 39-47MPH, 58-70 MPH.
What year did RAM switch to coil springs?
Ram trucks built starting in 2009 used a multi-link coil-spring rear suspension for better ride and handling. The coil-spring setup centralized and absorbed bumps and impacts, while reducing friction; it also weighed 40 pounds less than a leaf-spring configuration.
What are blue leaf springs?
BlueMax leaf springs are designed to maximise load carrying to improve stability and to increase ride height. Leaf springs are available in designs to suit specific ride requirements.
How do I know if I have a Dana 60 or 70?
Luckily, it’s pretty easy to tell which axle you have. The original factory axles in a Full Float Dana 60 always have 30 splines or less. If you pull an axle shaft out of your Dana and it has 33 or 35 splines, then you probably have a Dana 70.
What truck has a Dana 80?
Ford was the first company to use the Dana 80; it is used mostly in trucks with dual rear wheels with the exception being some Dodge 2500’s and select Ford F-350’s. The Dana 80 has a gross weight rating up to 11,000 lbs, however it is common practice among manufacturers to derate Dana 80’s.
What rear axle is in a 2013 Ram 2500?
The last year the AAM 1050 axle was used in Ram trucks was 2013. After 2013, the Ram 2500 was equipped with a new, coil sprung, AAM 1150 rear axle.
What axles are in a 2017 Ram 2500?
However, most of the 2500 and all 3500 Rams use Dana 60 front axles.