How do you make a Christmas hat out of paper?

Posted on

How do you make a Christmas hat out of paper?

STEPS

  1. 1Make a half-circle. Draw and cut out a half-circle with a radius of 9-10 inches (diameter 18-20 inches) on red construction paper.
  2. 2Create a cone. Form the half-circle into a cone.
  3. 3Glue cotton at the base. Glue cotton all around the base of the cone.
  4. 4Glue cotton at the tip.
  5. 5Wear the hat.

How do you make a paper elf hat?

Here are the instructions:

  1. First fold the construction paper in and cut off the excess forming a triangle.
  2. Then trace ears and cut them out.
  3. Then staple the two sides of the paper to form a cone and.
  4. staple the ears at the bottom of each side.
  5. Finally, glue the cotton ball to the top, and you are finished.

How do you make a hat brim out of paper?

Steps

  1. Crease a rectangular sheet of paper down the middle.
  2. Fold the paper in half width wise.
  3. Fold the top corners to the center crease.
  4. Fold 1 of the flaps along the bottom edge up.
  5. Fold the brim inwards if it is too wide for you.
  6. Flip the paper over and fold the second flap up too.

How do you make homemade elf hats?

Directions for DIY Felt Elf Hat

  1. Start by making a paper pattern for your hat.
  2. Cut out your triangle.
  3. Use scissors to round off the bottom of your triangle.
  4. Fold your large piece of green felt in half.
  5. Cut around your pattern.
  6. Fold your green felt again (if you unfolded it to check the shape).

How do you make elf hats out of paper?

How do you make an easy Santa hat?

STEPS

  1. 1Make a paper triangle. The first step is to make a hat pattern from paper.
  2. 2Tie a pencil to a string. Tape your triangle to a flat work surface.
  3. 3Draw an arc.
  4. 4Cut out.
  5. 5Prepare a sheet of felt or fabric.
  6. 6Trace the pattern onto the fabric.
  7. 7Cut the fabric.
  8. 8Join the straight edges together.

How do you make a gnome hat out of paper?

  1. Draw a circle.
  2. 2 & 3. Draw on the angle you want:
  3. Cut out the circle and segment.
  4. 5 & 6. Bend paper until you have a cone. Decorate at this point.
  5. Stick the hat together. Use. sellotape. or glue.
  6. Punch holes in opposite sides of hat. Add. string to. hold hat in place. find centre. of the circle. 45º 90º 135º