How many head bolts are on a 5.9 Cummins?

Posted on

How many head bolts are on a 5.9 Cummins?

5.9L 12 Valve Cummins Diesel Stock Head Bolts, set of 26.

Can you reuse Cummins head bolts?

Bolts with any signs of damage, no matter how slight, should never be reused. Not only will the bolts eventually fail, but when they do, there is the potential for them to cause damage to your cylinder head.

Are 24 valve Cummins reliable?

Cummins 5.9 24v Reliability Outside of the fuel system, the 5.9 24v is a very reliable engine. The engine internals such as the pistons, rod, and crankshaft will last a lifetime and can hold up beyond 500,000 miles.

What does VP44 stand for?

What is a VP44? A VP44 electronic rotary distribution pump that distributes and meters high pressure fuel required for injection. It is found on the 1998.5-2002 dodge Ram 2500 and 3500 light duty trucks. The VP44 pump can also be found on several mid-range and agricultural engines.

How many miles does a VP44 last?

Despite the favorable attributes, the 5.9L Cummins in this generation uses a VP44 injection pump (the weak link, if you will) known for lasting anywhere between 100,000 to 150,000 miles before it fails completely or throws OBD-II “death codes” at the owner for quite some time (P0216 is a popular one) before conking out …

What is the torque for the head bolt?

What is the torque for head bolts? If an engine produces 1,500 pounds of pressure and the cylinder head has 8 bolts, then each bolt must be tightened to 187 foot-pounds of torque to secure the cylinder head to the block.

What are the valve cover gasket bolt torque specs?

jeremy339. Does anyone know what the torque is on a valve cover gasket for a 2001 BMW E39?

  • Fudman
  • mrpumpk1n
  • chevelle01969. When you tighten the bolts down you will feel them stop.
  • xpcgamer. 5 Door’ing it!
  • jeremy339. Thank you all very much.
  • E39Convert. I think you run a chance of snapping the studs or bolts.
  • kmcguinn.
  • cn90.
  • MJB9.

    • How to torque cylinder head bolts?

    – Gen III (LS3, LS6, etc.) M11 x 155.5 mm bolts: 90 degrees – Gen III (LS3, LS6, etc.) M11 x 110 mm bolts: 50 degrees – Gen IV (LS2, LS3, etc.) M11 x 155.5 mm bolts: 70 degrees – For engines using M12 bolts, refer to the GM service manual

    What are the torque specs for rod cap bolts?

    Torque Spec: Main cap bolts: 95-105 ft-lbs: Connecting rod bolts: 40-45 ft-lbs. Cylinder