Why did my shock collar stop working?
Make sure your battery is charged in both the collar and the transmitter. Low battery charge can make for inconsistent functioning. Make sure both pieces are turned on and that the unit is properly synced so that the collar is receiving a signal from the transmitter.
What does red light mean on Sportdog collar?
Receiver Indicator Light
The Receiver Indicator Light comes on solid (red) and the Collar Receiver beeps continuously for 2 seconds. To extend the life between charging cycles, turn the Collar Receiver off when it is not in use.
How do you reset an electric dog collar?
Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5 times. You may need to hold both units 2-3 feet from each other before this occurs. Once the Receiver Indicator Light has flashed 5 times, the Collar Receiver has been reset and will begin flashing as normal.
Why is my dogs shock collar not shocking?
If BOTH contact points are not touching the dog’s skin, the dog will not perceive any sensation at all. This happens because the collar is on the dog too loose. When you are new to using an e-collar be aware that the fit is far snugger than any other collar you have likely put on your dog.
How do I reset my Sportdog bark collar?
How do you reset a Sportdog shock collar?
How do I get my Sportdog collar to vibrate?
VIBRATION:The Collar Receiver will vibrate when a Vibration button is pressed, up to a maximum of 10 seconds.
Why is my electric fence collar not working?
Make sure you’re testing the collar at the same height level as your pet. If you’re holding the collar at your waist and you have a small dog or cat, you may not hear the tone or feel the correction because you’re above the signal field.
How do you reset a stubborn dog collar?
To reset the low battery indicator, remove the battery from the Receiver Collar. Discharge all power by holding the correction level button down until the light is no longer illuminated. Reinstall battery.
How do I reset my Sportdog transmitter?
After the Receiver Indicator Light has turned off, release the On/Off Button. Press and hold the Continuous Stimulation button on the Remote Transmitter until the Receiver Indicator Light flashes 5 times. You may need to hold both units 2-3 feet from each other before this occurs.
How long does it take to charge a Sportdog collar?
Charge the Collar Receiver for 24 hours for the first charge. Recharges take only 12 hours. Note: The Receiver Indicator Light will flash after 12 hours of charging. For the first charge, continue to charge the Collar Receiver for an additional 12 hours.
Why is my dog fence not working?
Look For Simple Fixes First Collars should be tight enough that the posts touch your dog’s skin, but not so tight that you can’t insert one finger between the posts and your dog’s neck. Check the battery cap on the collar as well and tighten it if necessary.