Why does my Sony receiver keep saying protect?
If the impedance of any of the speakers is below the rated impedance range indicated on the rear of the home audio device next to the speaker connections, the home audio device may enter the PROTECT mode. Raising the volume with a low impedance speaker will trigger the protection circuit.
Why does my stereo keep saying protect?
Your stereo receiver is going into protection mode because the receiver has an internal short, a speaker is bad or the speaker wiring has a problem, such as incorrect wire gauge or bad connections.
How do I fix the Sony push power protector?
Turn off the home audio device, and remove all speaker wires from the back. Then turn the device back on and check if the issue is resolved. If it is still having the same issue, turn off the device again and let it rest for at least 30 minutes before turning it on again. Inspect the speaker cords.
How do I fix my Sony push power protector?
Turn off the home audio device, and remove all speaker wires from the back. Then turn the device back on and check if the issue is resolved. If it is still having the same issue, turn off the device again and let it rest for at least 30 minutes before turning it on again.
What is protect push PWR?
The PROTECT and PUSH POWER messages will flash alternately when the protective device of the amplifier has been activated because a strong signal was input, or if there is a short-circuit detected. To resolve the issue, turn the amplifier off and leave it off for at least 30 minutes.
How do I reset my Sony projector without remote?
How to reset the lamp hours on the projector.
- Connect the AC power cord to the projector.
- Wait till the ON/STANDBY indicator light is red.
- Press the Reset button.
- Press the left-arrow button.
- Press the right-arrow button.
- Press the Enter button.
How do I fix push power protect?
How do I get rid of push power protect?
Is there a reset button on a Sony receiver?
Press and hold down the MUTING and MUSIC buttons. While holding down the MUTING and MUSIC buttons, press and release the POWER button to turn the A/V receiver on. Wait approximately 5 seconds and then release the MUTING and MUSIC buttons.