Can you mic a bass drum without hole?
There are a couple of ways you can use a kick drum microphone inside of the drum but in this case, you’re looking at mic’ing the drum without that hole. The most obvious method is to place the microphone just up to the resonance head as close as possible without getting touched by the drum head when it’s played.
Should you gate live drums?
Gates destroy drums. It’s a harsh truth, but there’s no way a gate can accommodate the attack, sustain & release of every tom or snare hit without some quality loss. On one end, you’re fighting with attack times & making sure you’ve found the sweet spot for your threshold.
Why cut a hole in bass drum head?
Why? A bass drum hole on the lower half of the head gives more options for placing a microphone. Engineers can use a small or large boom stand, or a table-top stand for the bass drum mic. A port hole placed at the very bottom of the drumhead can sometimes be harder to mic.
How many Hz is a bass drum?
The frequency range of the bass and drums overlaps in the low frequency range through the low midrange. The attack of the bass is heard between 700 – 1000Hz, while the attack of the kick drum presents information at 3000 to 4000Hz.
Should I put a pillow in my bass drum?
The bass drum will eventually sound dead and flat – not what you want. The trick is to put a small amount of muffling in there. Try placing one pillow or blanket resting on the bottom of the drum. This way you get bit more control of the air flow, as well as the resonance on the drum head without killing the sound.
Should you compress drums live?
This is especially important with drums, which can have extremely sharp peaks on hits. Proper use of compression will let you clamp down on the tracks without crushing them, and also let you shape the snap, crack, and sustain you want in your drums.
Should you muffle your bass drum?
Can You MIC a bass drum from the outside?
In this case, the drummer can either choose to have a mic permanently installed inside the bass drum or live with the reduced attack by miking the bass drum from the outside. If the kick drum has a hole in the front head, interior placement is an easy way to capture a punchy and consistent kick drum sound.
What is the best microphone for miking drums during live performance?
The best microphones for miking drums during Live performance have to be able to reproduce the wide frequencies of sound that drums, cymbals and separate the rest of the noise that is happening on stage. Close miking especially in Rock music is necessary. It adds the punch and flavor while keeping the personality that each component carries.
How much does it cost to MIC a bass drum?
A setup of 3 mics that would mic your Bass drum, Snare and Tom would be approximately $350.00 for a quality set. This set-up uses an Overhead Drum Miking Technique includes the 2 overhead Pencil Condenser mics and a quality large Diaphragm Dynamic Kick Drum mic. The kit also comes with a pre-mixer that gets pretty good reviews from customers.
How do you play jazz drums with a bass drum mic?
The bass drum mic is always placed in front of the bass drum and never inside. Also, the jazz kit doesn’t have a hole in the bass drum resonant head. It would be best to change the grip to traditional and use the lighter sticks, so you get those “jazzy” ghost notes. Also, jazz drummers use a lighter drum beater.